6.0L LQ4 LS Engine with 2WD 4L80e and NEW Stand Alone Swap Harness PCM 4L80 GM

Description: This is your LS swap in a box! 6.0L LQ4 and 2wd 4L80e transmission. Includes belt driven accessories, a brand new stand alone swap harness and a PCM. Pulled from a running and driving 2004 Chevy 3500 Express van with 210320 miles. The van had a badly rusted frame and couldn't pass PA safety inspection. That's why it was scrapped. This LQ4 has all it's belt driven accessories. Includes all accessory mounts, tensioners, power steering pump, alternator, AC compressor, starter and even the motor mounts. The motor has been thoroughly inspected. The oil pan, windage tray and oil pickup tube were all removed to inspect for damage and then re-installed. Because of this the oil pickup tube O-ring will need to be replaced before running the engine. The only issue found during the inspection was a bad bearing on the belt idler pulley tensioner that will need replaced. The 4L80e includes the torque converter and the rear slip yoke. It also includes the torque converter cover. The cover is not in the pictures because I forgot to bolt it on before I took the pictures. But it is included. This transmission was rebuilt and has close to 50K miles on it. I personally drove this van to my shop to be scrapped, and it ran and shifted perfectly fine. Because of the mileage on these they are being sold as rebuild-able cores. Even though they could be installed as is. This includes a brand new stand alone swap harness with a fuse block and relays that will connect to both the engine and the transmission. This will work with both EV1 and Multec injectors because of the included adapters. I'm also including the PCM. The PCM will NEED programming before it can run this engine and transmission. I ship with Fastenal Blue Lane Freight. Everything will be fully crated. I will ship this to your local Fastenal store for pickup. Your local store will use a forklift to get you loaded. Please look at the last picture of a map in this listing very carefully. I can only ship this to a Fastenal store in the "East Zone". I can NOT ship this with Fastenal to a location in the "West Zone". If you need this shipped to an address in the "West Zone" you will need to arrange other freight on your own. After you check out I will need the zip code of the Fastenal store you would like this sent to. I will also need the name and phone number of the person who will be picking it up. Your local store will need ID to verify the identity of that person. If you have any questions please feel free to ask.

Price: 3495 USD

Location: Sligo, Pennsylvania

End Time: 2024-10-01T22:58:33.000Z

Shipping Cost: 350 USD