RCBS Case Trimmer Add on for RCBS Rotory Case Trimmer

Description: This is a 3D printed addon to the RCBS rotary case trimmer that eliminates the need for collets and pilots.This is for the older trimmers labelled "RCBS" on the casting, has the T-Handle, and the collets are inserted from the cutter side. It does not work on the "Trimmer 2", but I'll make one that does very soon. Eliminating the collets is the most important advantage gained by this addon. You don’t have to worry about getting the base into the collet consistently or having the same twist on the T-Handle every time. That would be impossible. Second is not having to get the case mouth the right size to match the pilot, and if you are a target shooter, you don’t have a pilot and shavings in the neck scraping off the powder residue. Third is the fact that the way the case is held inline between the head of the adjustment screw and the cutter, it squares the mouth. I have a lot of fired brass to test this on, and it is obvious that my previous trimming methods were not squaring the mouth. Shoulder bump is measured from to the base, and the mouth should be measured from the same point. About the Video.So it takes 90 seconds to setup by setting the cutter to the case mouth, moving the trim screw out .001" and trim it, measure the case to see how much more of the case needs to be trimmed, set the trim adjustment for that amount, and it's set. Case Holders.One Case Holder is included with your order. Message me the case type you need when you order. I do have an ad for additional Case Holders when you need them. Thanks for looking,

Price: 35 USD

Location: Bloomfield, Iowa

End Time: 2024-08-07T14:24:44.000Z

Shipping Cost: N/A USD